Audi 100

1982-1990 of release




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
- 3. Engines
   + 3.1. Four-cylinder engines
   - 3.2. Five-cylinder engines
      3.2.1. Removal and engine installation
      + 3.2.2. Dismantling and engine assemblage
   + 3.3. The diesel engine
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment





3.2.1. Removal and engine installation
PERFORMANCE ORDER
1. To disconnect a wire from "the minus" plug of the storage battery.
2. To remove a cowl (cм. Subsection 11.3 subitem 1-6).
3. To merge cooling liquid (subsection 4.1 subitem 1-3 see).
4. To remove a radiator (subsection 4.6 subitem 3-9 see).
5. To disconnect hoses of system of cooling from the engine.
6. To uncover the distributor of ignition and a high voltage wire.
7. To remove the air filter (cм. Subsection 6.1.2 subitem 1-6).
8. On cars with the steering hydraulic booster to remove the pump, without disconnecting hoses, and to fix its wire on a body.
9. On the cars equipped with the conditioner to remove the compressor, without disconnecting a hose, and to fix its wire on a body.
10. To disconnect electroconducting from knots and elements of the electric equipment established on the engine.
11. On the engines equipped with the carburettor to remove a ventilation hose картера, to disconnect a vacuum hose, to disconnect a cable of a drive throttle flaps, to disconnect from the fuel pump and the carburettor hoses of a supply and fuel tap, to remove the fuel pump.
12. On the engines equipped with system of injection of fuel to disconnect tubes of a supply of fuel to atomizers, to disconnect vacuum hoses from an idling regulator, to remove an air pipe connecting the gauge of the expense of air with a regulator of idling.
13. On engines with a turbo-supercharging to unfasten a cover of the air filter and to remove it together with an air line. To remove an air line which is passing from an intermediate cooler to the case throttle flaps. To remove a hose going from an intermediate cooler to турбокомпрессору. To remove an intermediate cooler. To remove a generator air line. To disconnect from the oil filter hoses of an oil radiator.
14. To turn away a fastening bolt картера couplings to the engine, located for a plug of deenergizing of coupling.
15. To remove теплоизоляционный a guard of the right arm of an engine mount.
16. To turn away the top bolts of fastening картера couplings to the engine.
17. To remove a starter (cм. Subsection 12.1.4.1 subitem 1-3).
18. To remove the generator (subsection 12.1.3.1 subitem 2-7 see).
19. To disconnect a reception pipe of the muffler from a final collector and from an arm on a transmission.
20. To establish under a transmission a jack and slightly to raise a transmission.
21. To turn away a nut of fastening of the right support of the engine to a body and the left support – to the engine.
22. To hang out the engine with the help тали or лебедки
23. To remove the left arm of an engine mount.
24. To establish the engine upside-down. Before installation to grease a primary shaft of a transmission and an end face of an internal ring выжимного the coupling bearing молибденовой with greasing.