Audi 100

1982-1990 of release

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
- 5. An exhaust system
   5.1. Removal and installation of system of release
   5.2. Ljambda-probe replacement
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

5.2. Ljambda-probe replacement

Types of applied ljambda-probes

1 – not warmed probe;

2, 3 – warmed probes

There are three types of the ljambda-probes applied on cars Audi. At replacement it is necessary to establish only the same probe what stood on the car.

1. To disconnect an electric socket of a probe from a plait of wires.
2. To turn out a ljambda-probe (fig. System of release of the fulfilled gases see) from a final collector.
3. To grease with special greasing VAG G5 a carving of a new ljambda-probe. To watch, that greasing has not got to cracks and probe apertures. Not to touch hands a working part of a new probe, to protect it from pollution.
4. To screw a ljambda-probe in a final collector and to tighten the moment 50 Нм (5,0 кгсм).
5. To connect an electric socket of a probe.