Audi 100

1982-1990 of release

12.2.3. Contactless system of ignition FEI

THE GENERAL DATA

Contactless system of ignition of engine RT of release since 1989

1 – connecting block the switchboard; 2 – connecting block the detonation gauge; 3 – the management block; 4 – a branch pipe of a supply of vacuum; 5 – connecting block the management block; 6 – a plait of wires; 7 – a sealing ring; 8 – the ignition distributor; 9 – the holder of the distributor; 10 – a bolt of fastening of the distributor; 11 – connecting block the Hall gauge; 12 – бегунок; 13 – a contact piece of coal;

14 – a distributor cover; 15 – the screen; 16 – the plug; 17 – a high-voltage wire; 18 – a candle tip; 19 – a spark plug; 20 – a control lamp on the panel of devices; 21 – the detonation gauge; 22 – the ignition switchboard; 23 – a bolt; 24 – the ignition coil; 25 – the plug «1» (–); 26 – the plug «15» (+); 27 – the plug «4»; 28 – a protective cap of the coil of ignition

Contactless system of ignition of engine MS with one gauge of a detonation

1 – the gauge of frequency of rotation of a cranked shaft; 2 – the gauge of a corner of an advancing of ignition; 3 – the detonation gauge; 4 – a ljambda-probe; 5 – the frequency valve; 6 – the management block; 7 – connecting block the management block; 8 – a vacuum hose;

9 – connecting block the gauge of a corner of an advancing of ignition; 10 – connecting block the gauge of frequency of rotation of a cranked shaft; 11 – connecting block the detonation gauge; 12 – connecting block ljambda-probe heating; 13 – connecting block a ljambda-probe; 14 – an arm

On models of later release the contactless system of ignition FEI is established. This system is similar described above electronic system of ignition.

It is necessary to consider that on engines MS of later releases two gauges of a detonation are established. System FEI has "memory" in which the information on possible malfunctions of system of ignition contains. This information can be "read" by means of the special equipment for diagnosing.

At work with system FEI it is necessary to carry out following security measures:

– It is forbidden to touch conducting, to separate and connect it, to connect to conducting of system of ignition any equipment (including for diagnosing) at the working engine;
– If it is necessary to turn the engine a starter, to disconnect block from the ignition switchboard;
– To scroll a starter with the help charger devices it is supposed no more than 15 with at pressure not above 16,5 In;
– To wash the engine it is authorised only at the switched off ignition;
– At performance of welding works on the car the storage battery should be completely disconnected;
– Before car towage it is necessary to disconnect block from the ignition switchboard;
– It is forbidden to change бегунок the ignition distributor on бегунок other type. The corner of an advancing of ignition is set by the block of management of ignition, however it can be checked up and adjusted how has been described earlier (subsection 12.2.1.3 see), thus it is necessary to disconnect a vacuum hose from the block of management of ignition.