Audi 100

1982-1990 of release




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
- 4. Cooling system
   4.1. Replacement of a cooling liquid
   4.2. Replacement and thermostat check
   4.3. Removal and installation of the water pump
   4.4. Check and replacement of the gauge of inclusion of the electrofan
   4.5. Replacement of the gauge of temperature of a cooling liquid
   4.6. Removal and installation of a radiator of system of cooling
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment





4.3. Removal and installation of the water pump
PERFORMANCE ORDER
1. To merge cooling liquid (subsection 4.1 subitem 1-3 see).
2. To remove a generator belt (subitem 4, 5 subsections 12.1.3.1 see).
3. At four-cylinder engines to remove the generator (subsection 12.1.3.1 see.). To remove a pulley of the water pump (fig. System of cooling of the four-cylinder engine see), to disconnect hoses from branch pipes in a back part of the case of the water pump. To turn away a nut and to remove a bolt, securing the the bottom cover (fig. of the Detail of a drive of a camshaft see) to the case of the water pump. To turn away bolts and to remove the water pump with a sealing ring (fig. System of cooling of the four-cylinder engine see). To turn away bolts and to uncover the pump with the platen and impeller, to remove a lining.
4. At five-cylinder engines to remove the top cover of a drive of a camshaft (fig. of the Detail of a drive of a camshaft see). To remove a belt of a drive of a camshaft. To turn away bolts of fastening of the water pump and to take out the pump (fig. System of cooling of the five-cylinder engine see).
5. To replace sealing rings (fig. System of cooling of the four-cylinder engine see) and (fig. System of cooling of the five-cylinder engine see) and a lining (fig. System of cooling of the four-cylinder engine see). To clear привалочные surfaces on a cover and the pump case.
6. To establish the pump upside-down. At the four-cylinder engine before installation to put on a lining of a cover a hermetic layer. To pull a belt of a drive of a camshaft (subsection 3.1.2.9 subitem 7-8, subsection 3.2.2.7 see). To pull a belt.