Audi 100

1982-1990 of release




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
- 6. The power supply system
   - 6.1. The power supply system of carburettor engines
      6.1.1. Replacement of a filtering element of the air filter
      6.1.2. Removal and installation of the air filter
      6.1.3. Temperature regulator check
      6.1.4. Check of the valve of a temperature regulator
      6.1.5. Removal and installation of the fuel pump
      6.1.6. Check of pressure of forcing of the fuel pump
      6.1.7. Removal and installation of a cable of a drive of an accelerator
      6.1.8. Adjustment of a cable of a drive of an accelerator
      6.1.9. Replacement of the gauge of level of fuel
      6.1.10. Removal and installation of a fuel tank
      6.1.11. Replacement of the filter of thin clearing of fuel
      6.1.12. Removal and carburettor installation
      + 6.1.13. Dismantling and carburettor assemblage
      + 6.1.14. Carburettor Pierburg adjustments 1B3
      + 6.1.15. Carburettor Pierburg adjustments 2Е2
      + 6.1.16. Carburettor Keihin adjustments
   + 6.2. The power supply system of engines with fuel injection
   + 6.3. The power supply system of the diesel engine
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment





6.1.8. Adjustment of a cable of a drive of an accelerator
PERFORMANCE ORDER
1. To disconnect a cable from the lever throttle flaps the carburettor.
2. To establish an accelerator pedal so that distance from a pedal against the stop on a floor there were 60 mm.
3. To establish the lever of a drive throttle flaps in idling position (throttle flaps are closed) and to attach to it a cable.
4. To pull a cable and to insert persistent bracket into the groove nearest to an arm on an adjusting tip of a cable.
5. To check up adjustment it is possible, having pressed an accelerator pedal against the stop. Thus the distance between the lever of a drive throttle flaps and an emphasis should be no more than 1 mm.