Audi 100

1982-1990 of release




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
- 3. Engines
   - 3.1. Four-cylinder engines
      3.1.1. Removal and engine installation
      - 3.1.2. Dismantling and engine assemblage
         3.1.2.1. Removal and installation of a head of the block of cylinders
         3.1.2.2. Removal of a camshaft and pushers of valves
         3.1.2.3. Camshaft survey
         3.1.2.4. Definition of a technical condition of hydropushers of valves
         3.1.2.5. Installation of a camshaft and pushers of valves
         3.1.2.6. Removal and installation of valves (dismantling of a head of the block)
         3.1.2.7. Survey, Troubleshooting and repair of details of a head of the block of cylinders
         3.1.2.8. Backlashes between cams of a cam-shaft and pushers of valves
         3.1.2.9. A camshaft drive
         3.1.2.10. Removal and installation of an intermediate shaft
         3.1.2.11. Removal and flywheel installation
         3.1.2.12. Replacement of epiploons of a cranked shaft
         3.1.2.13. Removal and installation oil картера
         3.1.2.14. Removal, check and installation of the oil pump
         3.1.2.15. Dismantling of shatunno-piston group
         3.1.2.16. Survey and check of details of shatunno-piston group
         3.1.2.17. Assemblage of shatunno-piston group
         3.1.2.18. Removal, survey and installation of a cranked shaft
   + 3.2. Five-cylinder engines
   + 3.3. The diesel engine
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment





3.1.2.11. Removal and flywheel installation
THE GENERAL DATA

On cars with an automatic transmission instead of a flywheel it is established driving a disk. An order of removal of a flywheel and drive a disk the identical.

PERFORMANCE ORDER
1. In regular intervals to turn out bolts of fastening of a flywheel on 1–2 turns.
2. To turn out bolts and to remove a flywheel from a cranked shaft. At removal drive a disk it is necessary to note an arrangement of linings.
3. To establish a flywheel or driving a disk upside-down. Before installation to put on a carving of bolts hermetic. Bolts to tighten the moment 100 Н·м (10,0 кгс·м). If driving a disk replaced, it is necessary to check up and if it is necessary to adjust its position. The distance from a back wall of the block of cylinders to an adjusting surface of the transformer on приводном a disk should be from 30,5 to 32,1 mm. To adjust position drive a disk it is possible, having established between it and cranked shaft a lining.