Audi 100

1982-1990 of release

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
- 3. Engines
   - 3.1. Four-cylinder engines
      3.1.1. Removal and engine installation
      - 3.1.2. Dismantling and engine assemblage Removal and installation of a head of the block of cylinders Removal of a camshaft and pushers of valves Camshaft survey Definition of a technical condition of hydropushers of valves Installation of a camshaft and pushers of valves Removal and installation of valves (dismantling of a head of the block) Survey, Troubleshooting and repair of details of a head of the block of cylinders Backlashes between cams of a cam-shaft and pushers of valves A camshaft drive Removal and installation of an intermediate shaft Removal and flywheel installation Replacement of epiploons of a cranked shaft Removal and installation oil картера Removal, check and installation of the oil pump Dismantling of shatunno-piston group Survey and check of details of shatunno-piston group Assemblage of shatunno-piston group Removal, survey and installation of a cranked shaft
   + 3.2. Five-cylinder engines
   + 3.3. The diesel engine
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment Camshaft survey
1. Carefully to wash out all details in gasoline or solar oil, to wipe and dry.
2. To examine cams and camshaft necks. If on cams and necks there are developments, teases, deep scratches, cracks etc., replace a camshaft.
3. To establish a camshaft in a block head, to establish covers of bearings of a camshaft, by the indicator to measure axial люфт a camshaft which should not exceed 0,15 mm. If люфт it is more – a camshaft replace.
4. To measure diameter of necks of a shaft. Nominal diameter of necks of 26,0 mm, admissible minimum diameter of necks of 25,75 mm. If diameter at least is less than one neck, it is necessary to replace a shaft.
5. To establish a camshaft on prisms and the indicator to measure palpation on an average neck: maximum permissible palpation of 0,01 mm. If palpation is more, a camshaft replace.