Audi 100

1982-1990 of release

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
- 6. The power supply system
   - 6.1. The power supply system of carburettor engines
      6.1.1. Replacement of a filtering element of the air filter
      6.1.2. Removal and installation of the air filter
      6.1.3. Temperature regulator check
      6.1.4. Check of the valve of a temperature regulator
      6.1.5. Removal and installation of the fuel pump
      6.1.6. Check of pressure of forcing of the fuel pump
      6.1.7. Removal and installation of a cable of a drive of an accelerator
      6.1.8. Adjustment of a cable of a drive of an accelerator
      6.1.9. Replacement of the gauge of level of fuel
      6.1.10. Removal and installation of a fuel tank
      6.1.11. Replacement of the filter of thin clearing of fuel
      6.1.12. Removal and carburettor installation
      + 6.1.13. Dismantling and carburettor assemblage
      + 6.1.14. Carburettor Pierburg adjustments 1B3
      + 6.1.15. Carburettor Pierburg adjustments 2Е2
      - 6.1.16. Carburettor Keihin adjustments Adjustment of frequency of rotation of start-up of the engine Adjustment of a starting backlash air flaps Adjustment приоткрывания throttle flaps the second chamber Adjustment of productivity of the accelerating pump Idling adjustment
   + 6.2. The power supply system of engines with fuel injection
   + 6.3. The power supply system of the diesel engine
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment Idling adjustment

Adjustment spend at correctly established moment of ignition and the switched off consumers of the electric power.

1. To warm up the engine to working temperature.
2. To connect a control tachometre and a gas analyzer according to the manufacturer instruction.
3. To adjust frequency of rotation of idling to (750–850) mines-1 the persistent screw of the lever throttle flaps the first chamber (it is shown by an arrow).
4. To disconnect a ventilation hose картера.
5. The screw (fig. the Screw of adjustment of quality (structure) carburettor Keihin mixes see) to establish maintenance level oxide carbon (WITH) in the fulfilled gases no more (1,00,5) %. To check up and if necessary to restore frequency of rotation of idling, and also the maintenance WITH in the fulfilled gases.